[. . . ] L When the batteries are fully charged, the charge indicator goes off. Rechargeable Ni-MH ONLY Confirm "Charging" is displayed. Note: L If the batteries are fully charged, but the operating time seems to be shorter, clean the battery ends (S, T) and the charge contacts with a dry cloth and charge again. For assistance, please visit http://www. panasonic. com/help 3 Controls A H A Charge indicator Ringer indicator Message indicator B Speaker C Soft keys D {C} (TALK) E {s} (SP-PHONE: Speakerphone) F Headset jack G Dial keypad ({*}: TONE) H Receiver I Display J {OFF} K Joystick L {FLASH} {CALL WAIT} M Microphone N Charge contacts I B C D E F G M N C J K L Registering a handset to a base unit 1 Base unit: NKX-TG6411 series Press and hold {LOCATOR} for about 4 seconds. (No registration tone) NKX-TG6421/KX-TG6431/KX-TG6441/KX-TG7431 series Press and hold {LOCATOR} for about 4 seconds until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. [. . . ] 4 {C} Call block (Caller ID subscribers only): Storing unwanted callers N From the caller list: 1 {MENU} (center of joystick) i {#}{2}{1}{3} 2 {V}/{^}: Select the entry to be blocked. i {SELECT} L To edit the number, press {EDIT} repeatedly until the phone number is shown in the 10-digit format. {SAVE} {V}/{^}: "Call block" i {SELECT} {V}/{^}: "Yes" i {SELECT} i {OFF} 3 4 5 Caller list: Editing a caller's phone number before calling back 1 {MENU} (center of joystick) i {#}{2}{1}{3} 2 {V}/{^}: Select the desired entry. i {SELECT} 3 Press {EDIT} repeatedly until the phone number is shown in the desired format. 4 {C} 10 For assistance, please visit http://www. panasonic. com/help Caller list: Storing caller information to the phonebook 1 {MENU} (center of joystick) i {#}{2}{1}{3} 2 {V}/{^}: Select the desired entry. i {SELECT} L To edit the number, press {EDIT} repeatedly until the phone number is shown in the desired format. {SAVE} {V}/{^}: "Phonebook" i {SELECT} Continue from step 2, "Editing entries", in the operating instructions. 3 4 5 For your safety To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product. WARNING Power connection L Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire. from the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. L Unplug the product from power outlets if it emits smoke, an abnormal smell, or makes an unusual noise. Confirm that smoke has stopped emitting and contact the Panasonic Call Center at 1-800-211- PANA (1-800-211-7262). Installation L To prevent the risk of fire or electrical shock, do not expose the product to rain or any type of moisture. L Do not place or use this product near automatically controlled devices such as automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction resulting in an accident. CAUTION Installation and relocation L The AC adaptor is used as the main disconnect device. Ensure that the AC outlet is installed near the product and is easily accessible. For assistance, please visit http://www. panasonic. com/help 11 Battery L We recommend using the supplied batteries or additional/replacement batteries noted on page 2 for replacement battery information. Released electrolyte from the batteries is corrosive and may cause burns or injury to the eyes or skin. Do not allow conductive materials such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit may cause the batteries and/or the conductive material to overheat and cause burns. [. . . ] La vente ou l'emploi de cet appareil dans certains autres pays peut constituer une infraction à la législation locale. LEste producto está diseñado para usarse en los Estados Unidos de América. La venta o el empleo de este producto en ciertos países puede constituir violación de la legislación local. [. . . ]